行业动态

当前位置:主页 > 新闻资讯 > 行业动态 >

AG环亚集团报道江苏南通电梯套厂家_AG环亚集团官网资讯

作者: AG环亚集团 时间:2018-07-11 来源:www.haohuijiancai.com
摘要:江苏南通电梯套厂家 晖建材13220589870 仿大理石ag电子捕鱼 的装置过程剖析 Analysis of the installation process of Jiangsu Nantong elevator set manufacturer Hui building material 13220589870 imitation marble elevator do...

江苏南通电梯套厂家晖建材13220589870仿大理石ag电子捕鱼的装置过程剖析
Analysis of the installation process of Jiangsu Nantong elevator set manufacturer Hui building material 13220589870 imitation marble elevator door

1、在墙面上覆上一面层,常用的是3MM的三合板,木匠板,好点是防火石塑uv板。用气钉把它们钉在墙面上,并用沙纸将板面清洁洁净。
1, on the wall to cover a layer, commonly used is 3MM's three ply board, carpenter board, the good point is fireproof stone stone UV board. Nail them on the wall with air nails and clean the boards with sandpaper.

2、锯板,将UV高光装饰板按实践要求锯成一块块的。
2, saw the board, UV high gloss decorative board according to practical requirements sawed together.

3、倒边,即将装置的UV板四边用倒边机倒成45度角。依据实践装置要求,有的只需倒上下两头或是三个边。
3, reverse side, the UV plate to be installed will be inverted 45 degrees to the side. According to the requirements of practical installations, some only need to top or bottom three sides.

4、清洁UV板反面,用沙纸和抹布将UV板反面清洁洁净。
4, clean the reverse side of the UV board, clean the UV plate side with sandpaper and rag.

5、把万能胶或木匠胶均匀涂在UV板反面,然后将UV板平整地贴在墙面上,再用手悄悄锤打UV板,让UV板愈加结实粘在墙面上。

5, a carpenter or carpenter glue evenly coated on the back of the UV board, and then the UV board flat on the wall, and then quietly hammered UV board, so that the UV board more strong sticky on the wall.

6、调水性填缝料,然后将填缝料填在两张UV板45度角相交处,先填满,再用木板垂直角从45度角相交处悄悄划过,这样相交处就美观了。
6, water adjustment filling material, and then fill the filling in the two UV plate 45 degree angle intersection, first fill, then the board vertical angle from 45 degrees angle cross section quietly, so the intersection is beautiful.

7、清洁UV板外表,将多余的填缝料清洁洁净。
7. Clean the surface of the UV board and clean the excess sealants.

联系我们
联系我们
AG环亚集团

联系电话:15853129351

地址:山东济南市历城区嘉恒大厦A座1201室

条评论
Sitemap